top of page
Call Us On: +919824072721
GSTIN: 24AAJCP4132K1ZF
PROTEKG POWER ELECTRONICS PRIVATE LIMITED
"SOLUTION DRIVEN COMPANY"
FLOAT CUM BOOST CHARGERS - DC POWER SUPPLIES
-
ProtekG has a 28 years of experience in designing and manufacturing of Industrial Float cum Boost charger chargers, BPS Industrial Float Chargers FCBC, FCBC Battery Charger
-
Float Charging are designed to supply a constant DC source for continuous load and intermittent DC loads and simultaneously keep the connected batteries in fully charged condition.
-
These are Constant Current – Constant Voltage chargers. Chargers are Transformers based, have a full bridge rectifier consisting of SCR / Diode or SCR-SCR modules with a phase angle control loop to automatically control the charging rate for a wide range of batteries.
-
BPS chargers are suitable for Float Charging all kinds of batteries like VRLA, Ni-Cad, Tubular, Plante, etc. Float Charging
​
TECHNICAL SPECIFICATIONS :
-
Configuration: 415V. AC ( 3 Phase) / 240 V (1 Phase)+/- 20 %/ +/- 10%, 50 Hz. +/- 3 Hz.
-
Output: 30 V, 48 V, 110 V, and 220 V. DC supply​
-
Battery Type: Lead Acid / SMF/PLANTE/ NiCd​
-
Indications and instruments: Indications for 3-phase mains supply
-
Float / Boost section
-
AC Volt meter with selector switch
-
DC Volt meter with selector switch and battery volt
-
DC Amps meter for load
-
DC Amps meter for Charging
5. Protection: MCB for Mains incoming supply Over Voltage cut-out circuit
Single phasing under voltage for mains MCB for output load
Overload cut out by electronics circuit
​
6. Cabinet Enclosure: Heavy-duty Sheet Steel Enclosure Finished with Powder Coated paint.
7. Operation: Auto/Manual
8.Control: CC/ CV close loop
9.Rectifier: Full wave half controlled bridge
10. Optional: Fuse protection for each rectifier element, Fuse failure relay
: DC Earth Fault Relay Alarm Annunciation
: Dual Float Charger option *Any other as per requirement.
bottom of page